sales@hunan-aerial-power.com    +8618684738272
Cont

Есть вопросы?

+8618684738272

Feb 15, 2020

Примечания о деталях подъема стрелы

Примечания к деталям подъема стрелы:

Чтобы не влиять на нормальное электроснабжение, иногда необходимо проводить проверку под напряжением низкого напряжения - поднятых частей стрелы для распределительных шкафов низкого - напряжения и другого оборудования - низкого напряжения , Общие детали подъема стрелы для технического обслуживания низкого напряжения - должны быть обращены на следующее.

1. There should be a personal guardianship. The purpose is that if an accident occurs during the overhaul, the guardian can immediately cut off the power (disconnect the circuit breaker or knife gate in the distribution cabinet, or unplug the fuse); in addition, when the overhauler may touch or overshoot When approaching the conductor or misoperation, the guardian can remind in time to prevent electric shock and other accidents.

2. Use tools with insulated handles, stand on dry insulation (such as wooden ladders, wooden tables, stools, etc.) when working, wear gloves (such as dry cloth gloves), and wear insulated shoes (such as rubber shoes, Plastic sole shoes). If you are working on the road, you should also wear a hard hat. Must wear long sleeves to work. It is strictly forbidden to use tools such as files, steel tapes, brushes with metal objects, threading screwdrivers and ordinary wire cutters.

3. При капитальном ремонте в ленточной линии низкого напряжения -, возводимой под высоким и низким напряжением на одном и том же полюсе или на платформе трансформатора, проверьте расстояние от заряженного корпуса высокого - напряжения по проводам и примите меры по предотвращению случайного контакта с заряженным корпусом - высокого напряжения. Если меры по изоляции не приняты для проводников низкого напряжения -, обслуживающий персонал не должен проходить через них. При работе с распределительными устройствами, такими как распределительные шкафы низкого напряжения -, должны быть приняты меры по изоляции для предотвращения короткого замыкания фазы - - - и однофазного заземления -.

4. Before climbing the pole, transformer stand or equipment, the phase line, neutral line and ground line should be distinguished, and the working position should be selected. When disconnecting the conductor, the phase wire should be disconnected first, and then the neutral or ground wire should be disconnected; when overlapping the conductor, the sequence is reversed. During the operation, the human body must not touch two threads at the same time.

5. Вторичные обмотки трансформатора напряжения и трансформатора тока должны быть надежно заземлены при капитальном ремонте счетчика ватта - и цепи реле в распределительном шкафу. При отсоединении токовой петли короткое замыкание - замыкает специальную клемму на вторичной стороне трансформатора тока.

6. Standing ladders and stools should be firmly installed, and someone underneath must be supported to prevent the maintenance personnel from sliding down.

7. When repairing the wiring pile heads where the phase line and the neutral line (two phase lines of different phases) are very close, such as the power switch, the terminal of the power distribution cabinet, the relay, the transfer switch, etc., should be carried out very carefully Power outages should be carried out for maintenance), eyes must not be close, otherwise it is easy to cause a short circuit accident and burn your eyes.

8. The live lift boom parts should pay attention to moisture and waterproof on the ground; outdoor live lift boom parts should be avoided on rainy days. On thunderstorm days, live lift boom parts should be stopped.

После завершения работ с деталями подъема стрелы, их следует тщательно проверить. Содержание проверки совпадает с проверкой при сбое питания.

Отправить запрос

Категории Продуктов